1.3.4 Measurement Lab - Skimmer

Step 1) Go to Canvas and make a copy of 1.3.4 MeasurementLabSkimmer into your GTT Turn in Folder with your initials at the end

Step 2) Watch the video below

Step 3) Use a ruler to mark all of the needed lines - dark lines will be cut along, dotted lines are for folding
Step 4) Cut, assemble and test your air skimmer then answer the 3 conclusion questions on your worksheet

Step 5) Turn in your worksheet from your GTT Turn in Folder

If the video above fails to load, try to watch it on YouTube at https://youtu.be/WpihN8RpTak

This video shows you step by step how to draw the lines for your skimmer.  Please use a ruler to practice your measuring skills and to make sure your lines are straight as they can be. In the video, I use a folder that is skinnier than yours - You will have extra room at the right side of your folder. Please realize that your folder is longer than the one I used, do not try to make yours look exactly like mine.

If the video above fails to load, try to watch it on YouTube at https://youtu.be/VXBZhGYIH9U

This video shows you step by step how to cut out the parts for your skimmer. Cut on the solid lines only.

If the video above fails to load, try to watch it on YouTube at https://youtu.be/fA6swSycRKA

This video shows you step by step how to assemble the parts your skimmer using glue and tape.

If the video above fails to load, try to watch it on YouTube at https://youtu.be/Y6-NJCcyDLk